Roof Truss Wall Plate

Be careful not to split the end of the truss and it would be a good idea to pre drill the end first before nailing.

Roof truss wall plate. Roof trusses attach to a ledger that is on top of a block wall. As an alternate to the roof truss anchor a bolted top plate may be used for the roof to wall connection see figure 5. Will all be fixed to them. However anchor bolt spacing must be reduced 24 in.

Start from the same end on both walls so that the sets of marks are parallel. This takes a little extra time but well worth the effort. Walls that are constructed of concrete block that need to be covered with a roof will require the use of a ledger. 610 mm maximum because the top plate is loaded in its weak direction.

Compare click to add item mitek 2 x 4 top plate truss clip to the compare list add to list click to add item mitek 2 x 4 top plate truss clip to your list sku 2271280. As with rafter style roofs toenailing is one of the most common ways of attaching a truss style roof to a wall plate. Step 2 stand the first truss on the end of the wall flush with the outside end of the wall. Fixing roof trusses to a wall plate requires a small amount of carpentry knowledge such as the abilities to read a tape measure and operate a framing square.

Workers manually move the first truss to the end of the roof and stand it up positioning it on the corresponding number on the wall plate. A ledger is a horizontal board that is attached to the top of the the wall. Place the roof rafter plate in place on top of the studs square and flush with the stud on one end of the wall. Take note where the other end of the rafter plate is in relation to the nearest.

Toenail a truss into the top of the wall plate by nailing through the sides of the bottom chord at a 30 degree angle. Otherwise setting roof trusses onto wall plates can be done by the average do it yourselfer usually in one to two days depending on the size and scope of the project. Once in place the workers nail the truss to the wall.